PowerPack

PowerPack ASME series commercial electric water heaters deliver a maximum of 190° F water and are designed for general use or point-of-use

Benefits

• Delivers 90-190° F water
• Installs close to fixtures, eliminating the wait for hot water
• Long-life ASME tank design: Proprietary steel formulation with high temperature porcelain enamel maximizes corrosion resistance
• Lifeguard^™ heating elements: Resist corrosion and burnout; separate screw-in type elements feature a stainless steel outer sheath of Incoloy^® 840, which surrounds the Nichrome wire filament
• Immersion thermostat
• Water Connections: Hot outlet and cold inlet are 3/4" NPT plastic lined nipples which prevent excessive turbulence of heated water and results in optimum tank draw

Efficiency

• 98 Percent maximum recovery efficiency
• Minimal heat loss: majority of the tank surface area is insulated with 2-1/2" rigid polyurethane foam insulation

System Sentinel

• Exclusive diagnostic system with glowing LEDs that verify heating element operation. LEDs pin point the exact location of functioning or non-functioning heating elements

Capacity & Dimensions

• 13 Gallons: 28-1/2" tall
• 19.9 Gallons: 36-1/2" tall
• 30 Gallons: 49-1/4" tall
• 40 Gallons: 53-3/4" tall

Plus…

• Integral fusing on each element
• Two magnesium anode rods for long life and corrosion resistance
• Full-flow, full-port, brass drain valve
• Temperature and pressure relief valve, factory installed
• Electrical Connections: Pre-wired, accessible control box with multipleknock-outs on side in size selections to match the National Electric Code. Sizes range from 1/2" to 2". A grounding screw is provided for attaching an equipment grounding conductor
• Single Panel Control Box with Hinged Door: Provides immediate access to all electrical components and elements
• Terminal Block: All models are equipped with U.L. listed terminal blocks for simplicity of installation. The terminal block will accept either copper or aluminum field connect wire
• 120 Volt Control Circuit: All units are furnished with a fused 120 volt control circuit. This circuit is created by an internal multi-tap transformer of unique design that has four (4) taps for the primary voltages, 208, 240, 277 and 480